10.Press the Emergency Stop button to stop the machine.

11.WITHOUT resetting the switch, press the Start button. The machine should not start.

—If the machine does not start, the Emergency Stop button safety feature is working cor- rectly.

—If the machine does start (with the stop button pushed in), immediately disconnect power to the machine. The Emergency Stop button safety feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

12.Reset the Emergency Stop button by twisting it clockwise until it pops out.

13.Turn the Power Switch key to the OFF posi- tion—the Power Lamp should go out.

The Power Switch is intended to prevent unauthorized use of this machine. The Power Switch does not disconnect the bandsaw from power. To avoid the risk of serious per- sonal injury, you MUST physically disconnect the bandsaw from the power source before performing adjustments, maintenance, or service to this machine.

14.Press the Start button.

—If the machine does not start, the Power Switch safety feature is working correctly.

—If the machine does start with the Power Switch key turned to the OFF position, immediately disconnect power to the machine. The Power Switch safety feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

If all of the Test Run procedures were successful, your bandsaw is ready for operation.

G0668 20" Vertical Metal-Cutting Bandsaw

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory.

However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the best possible results from your new machine.

Step-by-step instructions for these adjustments can be found in the SERVICE section starting on Page 34.

Factory adjustments that should be verified:

1.Lower wheel pulley alignment (refer to Page 36).

2.Tensioning V-belts (refer to Page 36).

NOTICE

After the first 16 hours of operation, new V-belts will stretch and seat farther into the pulleys. To avoid slippage, re-tension new V-belts after this period.

3.Wheel alignment (refer to Page 38).

4.Table alignment relative to the blade (refer to Page 40).

-15-

Page 17
Image 17
Grizzly G0668 owner manual Recommended Adjustments, Factory adjustments that should be verified