Grizzly G0668 owner manual Aligning Table to Blade, To adjust the table square to the blade

table alignment

��������

�����������������

�������������������������	����������
��������������������	������������

������������������������������� �������������������������

Figure 49. Examples of wheel orientation to one another.

Aligning Table to

Blade

To ensure the angle accuracy of the cut, the table must be 90° to the blade from front-to-back and side-to-side. If the table is not square to the blade, it needs to be adjusted.

Tools Needed:	Qty
Hex Wrench 5mm	1
Wrench 12mm	1
To adjust the table square to the blade:

1.DISCONNECT BANDSAW FROM POWER!

2.Make sure the wheels are correctly aligned (Page 38) and the blade is properly ten- sioned (Page 25).

3.Set the angle of the table to "0".

-40-

4.Use a square to check table alignment with the side and the back of the blade, as shown in Figure 50.

Figure 50. Checking table alignment with the

blade.

G0668 20" Vertical Metal-Cutting Bandsaw