-26- model g0719 (mfg. since 10/10)
table tilt Calibration
When the table is perpendicular to the sanding
disc, the scale should read 0˚. if not, follow this
procedure.
tools needed:
machinist's square .............................................1
phillips head screwdriver ...................................1
to calibrate the table tilt:
1. disCoNNeCt mAChiNe From poWer!
2. Using a try square or machinist’s square, set
one edge on the table surface and the other
against the face of the disc, as shown in
figure 26.
note: Although this can be done with the
sandpaper installed, it is more precise with-
out it.
3. loosen the lock handles and adjust the table
angle until it is perfectly perpendicular to the
disc, then tighten the lock handles while hold-
ing the table in place.
4. loosen the degree scale pointer, index the
pointer on 0˚, then retighten the screw.
5. recheck the scale accuracy with the square.
figure 26. squaring the table.