HandwheelsMotor
To mount the handwheels:
1.Position a handwheel over the arbor raising shaft on the front of the saw. Be sure it fits completely over the shaft. The slots in the handwheel hole will engage with the roll pin on the shaft as shown in Figure 12.
2.Position the other handwheel similarly on the blade tilting shaft located at the side of the saw.
3.Screw the black plastic lock knobs onto the ends of the shafts to lock the handwheels in place.
Roll Pin
Body mounted switch on
G1022SM and Z only
Figure 12. Mounting the handwheels.
The following pictures show the motor and V-belt included with the Model G1022SM and Z. The motor and belt included with the Model G1022ZF, ZFX and PRO will look slightly different but will assemble in the same manner as shown.
To mount the motor:
1.Turn the motor upside down and attach the motor plate using M8-1.25 x 25 hex bolts, 8MM flat washers and M8-1.25 hex nuts as shown in Figure 13. Finger-tighten only.
Note: Motor comes
pre-wired.
Figure 13. Attaching the motor plate.
2.Insert the 1Ú4''-20 x 2'' hex bolt through the hole in the pulley guard bracket as shown in Figure 14.
| Figure 14. Attaching pulley guard bracket. |
G1022 Series Contractor Saws |
