Grizzly G1531 manual Beginning Assembly Feet

SECTION 2: ASSEMBLY

Beginning Assembly Feet

Assembly of the G1531 is straightforward. We have organized the assembly process into steps. Please follow them in sequence.

All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is removed at the factory. Sometimes a bit of flashing might escape inspection. Please examine the edges of all die-cut metal parts before handling them. Serious personal injury may occur.

Tools Required: Only a few common tools are needed to assemble this machine. Specifically, a 6" adjustable wrench, 12mm open end wrench, regular and Phillips® screwdriver.

1.Carefully lay the machine over on its side. Have someone assist you when doing this.

Do not attempt to lay to machine over by yourself. Serious personal injury may occur.

2.Install the four feet using the 10-24 x 3⁄4'' Phillips® Head Screws provided. Figure 3. Get assistance and stand the machine up.

Figure 3. Installing the foot pads.

-8- G1531 Edge Sander