Table Tilt
1.Loosen the lock handles, tilt the working table to the desired angle and retighten the lock handles. Figure 20.
2.It may be necessary to
1⁄4'' gap should exist between the platen and the working table.
Figure 21.Table height adjustments.
Belt Tension
|
|
| Belt tension is preset at the factory and usually | |
|
|
| requires no adjustment. If the need to increase | |
|
|
| the tension should occur, unthread the retaining | |
|
|
| nut (arrow) at the end of the idler roller mounting | |
Figure 20. Lock handle underneath the table. | ||||
shaft. Figure 22. Do not unthread the nut more | ||||
|
|
| ||
|
|
| than 1⁄2 its length. If tension problems persists, | |
|
|
| ||
|
|
| call the service center for further help. | |
|
|
| ||
|
|
|
| |
Table Height
1.Loosen lead screw lock handle and stabiliz- ing shaft lock bolt. Figure 21.
2.Turn hand wheel and position working table to desired height.
3.Retighten lock handle and lock bolt.
Figure 22. Belt tensioning mechanism.
G1531 Edge Sander |
