Belt Installation
1.Loosen the belt tracking lock knob on the top left of the machine. Open the lid of the dust port and move the quick release lever to its locked open position. Figure 16.
Figure 16. Sander ready for belt installation.
2.Check the back side of the belt for an arrow indicating direction of rotation. The sanding belt rotates counter-clockwise.
3.Slide the belt over the rollers. Move the quick release lever back to its tensioned position. Figure 17. Belt tracking is covered in the next section.
Figure 17. Belt installed.
Avoid placing hands close to pinch points. These are located where the sand- ing belt meets the rollers and along the inside edge of each work table. Serious personal injury may occur.
|
|
|
|
|
|
|
|
|
|
|
|
G1531 Edge Sander | |||
