7.Measure the table bracket to the stand to assure it is parallel to the stand. Figure 8. If the bracket is not parallel, remove the verti- cal brace, thread the horizontal brace in or out an appropriate amount and reinstall the vertical brace.
Figure 8. Checking table bracket for parallelism.
8.Once the table bracket has been properly adjusted, tighten the horizontal brace jam nut and the two Hex Nuts that hold the verti- cal brace in place.
9.Attach the table trunnions to the table brack- et. Each is held in place with a 3/8'' Flat Washer and lock handle. Figure 9. The trun- nion with the scale attaches to the left side.
Figure 9. Table trunnions installed.
10.Leaving the table trunnion lock handles slightly loose, bolt the working table to the trunnions using the two 5⁄16''-18 x 3⁄4'' Hex Bolts and 5⁄16'' Flat Washers supplied. Figure 10. Adjust the table so it is approximately 1⁄8'' to 3⁄16'' from the edge of the sanding platen and tighten the mounting bolts.
Figure 10. Attaching the working table.
11.Adjust the work table 90˚ to the sanding plat- en by checking it with a square. Adjust as necessary and tighten the table lock han- dles. At this point adjust the pointer to 90˚.
Figure 11.
Figure 11. Setting the pointer to 90˚.
G1531 Edge Sander |
