Grizzly G1531 manual Maintenance, GeneralTable, Lubrication

SECTION 5: MAINTENANCE

GeneralTable

Before performing any type of inspection or maintenance work, be sure that the power cord is unplugged and all moving parts have come to a complete stop. Serious personal injury may occur.

Make a habit of inspecting your sander each time you use it. Check for the following conditions and repair or replace when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged sanding belt.

5.Any other condition that could hamper the safe operation of this machine.

Lubrication

Shielded and pre-lubricated ball bearings require no lubrication for the life of the bearings. In a con- tinuous-use environment, expect the bearings to last for several years. With intermittent use, bear- ings can be expected to last much longer. All bearings are standard sizes and can be easily replaced.

The table and other non-painted surfaces on the Model G1531 should be protected against rust and pitting. Wiping the sander clean after every use ensures that moisture from sander dust isn’t allowed to trap moisture against bare metal sur- faces.

Some woodworkers recommend using automo- tive paste wax on exposed steel and cast iron surfaces. The wax provides a layer of protection, as well as reducing friction between lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone or other synthetic ingredients. These materials can find their way into lumber that’s being worked, and can make staining and finishing difficult. If you use paste wax, make sure that it’s 100% Carnauba wax.

G1531 Edge Sander -19-