SECTION 2: CIRCUIT REQUIREMENTS
110V Operation
Serious personal injury could occur if you connect the machine to power before com- pleting the setup process. DO NOT connect the machine to the power until instructed later in this manual.
Electrocution or fire could result if machine is not grounded and installed in compliance with electrical codes. Compliance MUST be verified by a qualified electrician!
Full Load Amperage Draw
This machine draws the following amps under maximum load:
Amp Draw | 1.2 Amps |
Power Supply Circuit Requirements
You MUST connect your machine to a grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing cir- cuit with one of higher amperage without consult- ing a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to con- nect your machine to a shared circuit, consult a qualified electrician.
Minimum Circuit Size | 15 Amps |
Model G4173 1⁄8 HP Power Feeder
Power Connection Device
The Model G4173 comes with a
<gdjcY^c\Egdc\^h Adc\Zhid[i]ZI]gZZ Egdc\h
8jggZci 
8Vggn^c\Egdc\h <gdjcYZY
DjiaZi
Figure 2. Typical 5-15 plug and receptacle.
This machine MUST have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a
Extension Cords
We do not recommend using extension cords, but if you find it absolutely necessary:
•Use at least a 16 gauge cord that does not exceed 50 feet in length!
•The extension cord must have a ground wire and plug pin.
•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.
