Downfeed Handles &
Belt Cover Knob
Components and Hardware Needed: | Qty | |||||
Downfeed Handles | ............................................ |
| 3 | |||
Cover Knob 1⁄ |
|
| 1 | |||
4 |
|
|
| " | 1 | |
Phillips Head Screw 1⁄ | ||||||
Flat Washer 1⁄ |
| " | 4 | 2 |
| 1 |
|
|
|
| |||
4 |
|
|
|
|
| |
The downfeed handles must be installed to oper- ate the drill press.
To install the downfeed handles:
1.Thread the downfeed handles into the pinion hub, as shown in Figure 12.
Belt Cover
Knob
Pinion
Hub
Figure 12. Downfeed handles installed.
2.Remove the screw that fastens the belt cover in place and install the belt cover knob in its place.
Light (110V Only) |
|
Components and Hardware Needed: | Qty |
60W Light Bulb (not included) | 1 |
The Model G9969 includes a light socket, intend- | |
ed for 110V usage only. When the drill press is | |
shipped from the factory, a dust plug is installed | |
in the light socket for protection. |
|
To install a light bulb in the drill press: |
|
1.Remove the dust plug from the light socket.
2.Install a 60W or smaller light bulb in the loca- tion shown in Figure 13.
Light Bulb
Access Here
Figure 13. Light bulb access location.
The light socket includ- ed with this drill press is for 110V USE ONLY. If the light socket is used while operating at 220V, the light bulb WILL EXPLODE, poten- tially causing serious personal injury.
G9969 Radial Drill Press |
