Sound Hole Decal
To attach the sound hole decal:
1.Submerge the decal sheet in water until the clear decal slides around on the paper back- ing easily with finger pressure. This usually only takes a few minutes.
2.Remove the decal sheet from the water, let- ting the excess water run off.
3.Lay the decal sheet over the sound hole.
4.Lightly press down on the decal with damp- ened fingers and slowly slide the decal sheet from underneath the decal with the other hand.
5.When the decal sheet is completely removed, lightly press on the decal with a dry cloth to remove the excess water trapped under- neath.
Attaching Bridge
To attach the bridge to the body:
1.Remove the masking tape from the bridge location.
2.Apply a thin, even layer of wood glue to the back of the bridge.
3.Position the bridge on the bridge location penciled on the body.
4.Make sure the bridge is correctly positioned and let it dry for at least 6 hours.
5.Using a 1⁄8" drill bit, drill out the two mounting holes in the bridge.
6.Secure the bridge to the body with the sup- plied screws, washers, and nuts.
7.The heads of the screws can be covered with the bridge decoration sticker.
H3122 Classical Guitar Kit |
