Grizzly H6086, H6082, H6083 instruction manual Installing the Tuners, To install the tuners

Installing the Tuners

Each tuner consists of the tuner, washer, and a barrel nut. The tuners are attached to the head- stock with a small wood screw that attaches between the tuners.

Components Needed	Qty
Guitar	1
Tuner	6
Washer	6
Barrel Nut	6
Tap Screw M2 X 12	6
Tools Needed
Peghead Reamer or Round File	1
Phillips Head Screwdriver	1
Drill Press with a 1⁄16" Drill Bit	1
To install the tuners:

1.Place the six tuners into the holes on the back of the headstock. The holes may need to be widened with a peghead reamer or a round file. DO NOT widen the holes too much—the tuners should fit snug.

2.Slide a washer over the tuner shaft and screw the barrel nut onto the tuner.

3.Align the tuners perpendicular to the edge of the headstock and parallel to each other. Use a strip of masking tape to secure their position on the headstock.

4.Using a 1⁄16" drill bit in a drill press, drill 3⁄8" deep holes into the headstock. Note—Drilling the holes deeper than 3⁄8" could result in drill- ing out through the front face of the head- stock. Use a depth stop or tape wrapped around the drill bit at the correct depth as an indicator.

5.Secure the machine heads to the guitar headstock with the tap screws.

Figure 14. Completed peghead.

Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits -11-