Winding Strings on
the Model H6086
The correct position of the guitar strings is shown in Figure 31. The thin High E string is the "1st" string and the thick Low E string is the "6th".
To install the guitar strings:
1.Cut the ball ends and wraps off of the guitar strings.
2.Insert the strings between the lock block and the front edge of the lock box as shown in Figure 35.
�
�
�
�
�
�
� �
���� ����
� �
Figure 31. Correct string locations.
Components Needed | Qty |
Strings | 6 |
Tools Needed |
|
Wire Cutters | 1 |
Hex Wrench 3MM | 1 |
Saddle Lock Screw |
Fine Tuner |
Lock Block |
Lock Box |
Figure 34. Bridge components.
Figure 35. Strings locked into lock box.
3.Tighten the saddle lock screws.
4.Guide the strings over the nut, and through the hole in the corresponding tuners.
5.Allow only enough slack in the strings for 2-3 rotations around the tuner. Note—If too much slack is allowed, then the strings could wind off the machine head after many successive rotations. If not enough slack is allowed, then the strings may not hold the winding tension.
6.Bend the strings at a right angles across the edge of the machine heads.
7.Rotate the tuners until the strings just begin to hold the winding tension. Note—DO NOT tighten the strings beyond the initial tension- ing at this time. Final tensioning should be completed during the string tuning process.
8.Use wire cutters to cut off the excess string.
Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits |
