Grizzly H6330 instruction manual Tank Assembly, To assemble the paint tank

6. Connect a 1/4" NPT material hose (not included) to the fluid outlet adapter on the tank lid.

7. Install a pressure regulator (not includ- ed), between the tank regulator, (Figure 3) and the spray gun, since some of the pressurized air from the compressor will bypass the tank regulator.

Figure 3 depicts the paint tank con- nected to a compressed air system with a filter/regulator unit and a spray gun.

The filter/regulator unit protects your tool from damaging water build-up, and allows you to adjust and maintain regulated air pressure. If you plan on installing a filter/regulator unit in your compressed air system, follow the con- nection instructions with the unit.

Tank Assembly

		Pressure Gauge
				Lift Handle
Regulator Assembly
	Air Inlet Fitting
			Air Outlet Fitting

Fluid Outlet Adapter

Safety Valve

Figure 2. Regulator and lift handle installed on paint tank.

To assemble the paint tank:

1. Apply pipe thread tape to all male pipe threads.

2. Thread the lift handle into the center hole on the tank lid (see Figure 2) and secure with the hex nut.

3.Thread the regulator assembly onto the

swivel adapter on the lid, as shown in Figure 2.

4.Connect a 1/4" NPT air supply hose

(not included) to the inlet fitting on the regulator.

5. Connect a 1/4" NPT air supply hose (not included) to the air outlet fitting on the opposite side of the regulator.

6idb^oVi^dc 6idb^oVi^dc

6^g=dhZ6^g=dhZ GZ\jaVidg

HegVn

<jc

BViZg^Va=dhZ

IVc`

GZ\jaVidg

Fj^X`	Fj^X`
8dccZXidg	8dccZXidg	GZ\jaVidg
		6^g
		8dbegZhhdg
Fj^X`
8djeaZg

Fj^X`

6^g 8djeaZg

Hjeean;^aiZg =dhZ

Figure 3. Paint tank connect to air compressor and spray gun.

-6- Model H6330 21⁄4 Gallon Paint Tank