Safety Yoke
A safety yoke mechanism on the nose of the nailer/stapler acts as a safety device. When the trigger is pressed, the nailer/ stapler will not fire until the safety yoke mechanism is depressed.
Before you use your nailer/stapler for the first time, check the safety yoke mecha- nism to ensure proper function. To do this:
1.DISCONNECT NAILER/STAPLER FROM THE AIR SUPPLY!
2. Make sure the magazine is empty and contains no nails/staples.
3.Make sure the trigger and the safety yoke mechanism move up and down without sticking.
4.Connect the nailer/stapler to the air supply.
The safety yoke is a mechanical device that can fail. Never rely on the safety yoke mechanism as an excuse to point the nailer/stapler at yourself or any bystanders. Serious injury may occur.
5.Without pressing the trigger, depress the safety yoke mechanism against a scrap piece of wood that is clean and free of any knots, nails, or other foreign objects.
—If the nailer/stapler does not fire, then the safety yoke mechanism is working correctly.
—If the stapler does fire when you do this, immediately disconnect the stapler from the air supply and call Grizzly Technical Support at (570)
—If the stapler fires when the trig- ger is pulled, without the safety yoke mechanism being depressed, disconnect the stapler from the air supply and call Grizzly Technical Support at (570)
—If the stapler is not working properly, check the lubrication of the sliding mechanisms of the safety yoke.
H7664 |
