Grizzly H7664 instruction manual Operations, Loading, Operating, To load your nailer/stapler

SECTION 4: OPERATIONS

Loading

When replacing brads or staples in your Model H7664, follow these guidelines:

Gauge: 18

Brad Length: 5⁄8"-2"

Staple Length: 5⁄8"-15⁄8" (crown 1⁄4")

Capacity: 100

To load your nailer/stapler:

1.DISCONNECT NAILER/STAPLER FROM THE AIR SUPPLY!

2.Grip the nailer/stapler firmly, unlatch the catch lever (Figure 3), and pull the magazine pusher back completely.

Figure 3. Catch lever engaged and

magazine pusher retracted.

3.Insert a strip of brads or staples, point- ed-end down, into the magazine as shown in Figure 4.

Pusher

Magazine

Sight Window

Figure 4. Loading nails into magazine.

4.Slide the staples or brads all the way down to the nose of the nailer/stapler.

5.Push the magazine toward the nose of the nailer/stapler until the catch lever locks.

6.Reload the nailer when the magazine sight window (Figure 4) shows the nail or staple level is low. The sight window shows up to approximately 50 nails or staples loaded.

Operating

If you have not read the safety instruc- tions in this manual, do not operate the nailer/stapler.

Before you operate your nailer/stapler, place two to three drops of the included oil into the quick connect fitting where the nailer/stapler connects to the air supply.

To operate your nailer/stapler:

1.Connect the air supply to the quick connect fitting.

-12- H7664 2-in-1 Combination Nailer/Stapler