Single/Bump Fire | Clearing Jammed | |
Operation | Nails/Staples | |
|
|
|
|
|
|
The nailer/stapler is designed to fire one nail/staple at a time, or one after another, using the safety yoke mechanism. This is known as "bump fire".
To operate your nailer/stapler in single fire mode:
1.Depress the safety yoke mechanism against the workpiece.
2.Pull the trigger, then remove your finger from the trigger after the nail/staple is driven.
To operate your nailer/stapler in bump fire mode:
1.Pull the trigger.
2.Press the safety yoke mechanism against your workpiece and raise it after the nail/staple is driven.
3.Hold the trigger and repeat Step 2 to drive more nails/staples.
A jammed nail or staple must be cleared before using the nailer/stapler again.
To clear a jammed nail or staple from the magazine:
1. DISCONNECT THE NAILER/ STAPLER FROM THE AIR SUPPLY!
2. Unlock the catch lever and pull the magazine pusher back completely.
3.Locate and remove the jammed nail/ staple with a pair of needle nose pli- ers.
4.Throw the damaged nail/staple away.
5.Inspect the nail/staple stick. If it is bent or damaged, throw it away and insert a new stick that only contains clean, undamaged nails/staples. DO NOT use dirty or damaged nails/staples!
6.Push the magazine pusher forward to the front of the magazine until the catch lever locks.
H7664 |
