Grizzly H7762 owner manual Circuit Requirements, 110V Operation

SECTION 2: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you connect the machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.

Amperage Draw

The Model H7762 motor draws the following amps under maximum load:

Motor Draw 6.3 Amps

Circuit Recommendations

We recommend connecting this machine to a dedicated circuit with a verified ground, using the circuit breaker size given below. Never replace a circuit breaker with one of higher amperage with- out consulting a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared cir- cuit, you may create a fire hazard—consult a qualified electrician to reduce this risk.

Circuit Breaker....................................... 15 Amps

Plug/Receptacle Type

Included Plug Type NEMA 5-15

Figure 2. Typical type 5-15 plug and receptacle.

-8-

Electrocution or fire could result if this machine is not grounded correctly or if your electrical configu- ration does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!

This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a two-pronged outlet! If the plug will not fit the outlet, have the proper outlet installed by a qualified electrician.

Extension Cords

We do not recommend the use of extension cords. If you find it absolutely necessary:

•Use at least a 16 gauge cord that does not exceed 50 feet in length!

•The extension cord must also contain a ground wire and plug pin.

•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.

H7762 Heavy Duty Tool Grinder