Grizzly Model G0550 instruction manual Extension Rollers, Bed roller

Extension Rollers

Components and Hardware Needed: Qty
Extension Rollers	2
Tools Needed:
12/14mm Combo Wrench	1
Allen Wrench 4mm	1
To install the extension rollers:

1.Do not connect the planer to a power source!

2.Remove the three hex bolts and washers from below the outfeed and infeed tables.

3.Position the extension rollers over the holes.

4.Finger-tighten the hardware removed in step 2 to secure the extension rails to the planer as shown in Figure 11.

Hex Bolts

Level Adjust

Setscrews

Figure 11. Extension rollers.

5.Loosen the bed roller setscrews and turn the eccentric shaft so the table rollers are beneath the table surface. See Figure 12.

Setscrews

Figure 12. Bed roller.

6.Use a straightedge to check table-to-exten- sion roller alignment as shown in Figure 13.

Figure 13. Checking extension roller alignment..

7.Adjust the leveling setscrews shown in Figure 11 if the table and extension rollers are not flush.

G0550/G0551 15" Planer -17-