Thickness Scale
The thickness scale, located below the hand- wheel, can be adjusted for accuracy. However, material must be run through the machine to adjust the thickness scale. Make certain you have followed the directions in the Operations Section for test running before attempting to make these adjustments.
To adjust the scale:
1.Adjust the cutterhead height to the approxi- mate thickness of your test lumber. Measure the lumber with calipers to determine its exact thickness.
2.Move the cutterhead to 1⁄16" under the thick- ness of your lumber and feed your test board through the planer.
3.Turn the handwheel one half rotation and run the board through once more. Turn the board over and repeat.
4.Measure the board again and compare your results with the scale. If there is a discrepan- cy, loosen the scale adjustment screw and correct the position. See Figure 30.
Figure 30. Screw for column adjustment.
G0550/G0551 15" Planer |
