Assembly
Assembling the Model T23036 consists of install- ing the foot pedal assembly and the front and rear extension arms assemblies. Installation of the extension arms is an optional step that is depen- dent on the operations you plan to perform.
To assemble the foot shear:
1.At the lower rear of the machine, loosen the set screws that hold the hinge pins in place and slide them outward (Figure 7).
Hinge Pin
Set Screw | Foot Pedal Assembly |
|
Figure 7. Hinge pin & foot pedal.
2.With the help of an assistant, align the foot pedal assembly with the hinge pin and slide the hinge pin back in.
3.Tighten the set screws to hold the hinge pins in position.
4.Attach the two blade yokes to the arms of the foot pedal with the M14-2 x 50 bolts, washers and nuts, and tighten in position (Figure 8).
Blade Yoke |
Arm |
Foot Pedal Assembly |
Figure 8. Foot pedal assembly.
-12-
5.Loosen, but do not remove the four 19mm hex bolts on the front of the table.
6.Place the front extension arms over the hex bolts and behind the special washers (Figure 9).
Hex Bolt
Special Washer
Extension Arms
Figure 9. Front extension arm installed.
7.Line up the channel of the front extension arm with the channel on the table.
8.Make sure the ground flat surface on the front extension arms is flush with the top of the table surface.
9.Tighten the hex bolts and check to make sure the alignment is still intact. If it is not, re-adjust as necessary.
10.Slide the front work stop into the extension arms. When the foot pedal, front exten- sion arms, and work stops are installed, the machine should look like Figure 10.
Front Extension
Arms
Work Stops
Foot Pedal
Figure 10. Foot pedal and front extension arms.
T23036 37" Foot Shear
