model t23108 (mfg. since 7/10) -13-
Assembly
the model t23108 is shipped partially assembled.
perform the following procedure to complete the
assembly.
To assemble the sharpener:
1. make sure the base is firmly mounted to the
workbench.
2. insert the swing arm pivot stud into the
matching hole in the vertical face of the base
(see figure 8).
3. While holding the swing arm in place, insert
the m10-1.5 x 40 hex bolt through the hex-
shaped hole in the swing arm vertical face,
then secure the arm to the base with the
10mm fender washer and m10-1.5 lock knob,
as shown in figures 9–10.
4. thread the handle onto the end of the swing
arm, as shown in figure 11.
figure 8. swing arm pivot stud and matching
hole.
pivot stud
& hole
Base
Vertical Face
figure 9. swing arm hex bolt inserted.
hex Bolt
swing arm
assembly
figure 10. swing arm lock knob installed.
lock
Knob
figure 11. swing arm handle attached.
handle