Setting the clock
The first time you connect the
1In standby mode, press and hold »PROG« on the remote control for 2 seconds.
– Display: »12 H« or »24 H«.
2 Press »3« or »4« on the
– Display: The clock digits for the hours flash.
3Select the hours with »3« or »4« on the
– Display: The clock digits for the minutes flash.
4 Select the minutes with »3« or »4« on the
– Display: the current time.
Switch off or on the RDS time synchronisation
Some RDS stations transmit an RDS time signal. If the selected RDS station transmits time infor- mation, the time is updated automatically, if you have set »CT ON«. This takes about five minutes.
1 Switch on the
2Select the input source TUNER with »SOURCE« on the
3 Press and hold »DISPLAY« on the remote control for 2 seconds.
– Display: »CT ON« flashes.
4 Switch the RDS time synchronisation off or on with with »3« or »4« on the
Notes:
7The current time is displayed in standby mode – with reduced brightness.
7The time must be reset after a power failure or after disconnecting from the mains.
Tuning and storing radio stations
You can store up to 30 stations in the FM and 10 stations in the AM frequency range on pre- sets.
Note:
7For the best FM (VHF) reception, it is suffi- cient to direct the wire antenna accordding- ly.
Programming radio stations
1 Switch on the
2 Select the input source TUNER by pressing »SOURCE« on the
3 Select the desired wave range (FM or AM) by pressing »SOURCE« on the
4Set the radio station by briefly pressing »3« or »4« repeatedly.
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down »3« or »4« until the frequency changes to rapid
5To store the radio station, press »PROG«, se- lect preset by pressing »+ PRESET
6To search and save more radio stations, repeat steps 3 to 5.