JVC RX-8020VBK manual Down Tuning UP

English

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning into Stations Manually Using Preset Tuning

On the front panel:

1. Press FM/AM to select the band	FM/AM
(FM or AM).

The FM/AM lamp on the front panel button lights up. The last received station of the selected band is tuned in.

•Each time you press the button, the band alternates between FM and AM.

ANALOG	L	R	TUNED	STEREO
	SPEAKERS 1			VOLUME

Once a station is assigned to a channel number, the station can be quickly tuned in. You can preset up to 30 FM and 15 AM stations.

To store the preset stations

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

On the front panel ONLY:

1. Tune in the station you want to preset (see

“Tuning into Stations Manually” on the left).

• If you want to store the FM reception mode for this station,

select the FM reception mode you want. See “Selecting the

FM Reception Mode” on page 28.

2.Press FM/AM TUNING 5 or ∞ until you find the frequency you want.

•Pressing FM/AM TUNING 5 increases the frequency.

•Pressing FM/AM TUNING ∞ decreases the frequency.

From the remote control:

1. Press FM/AM to select the band (FM or AM).

The FM/AM lamp on the front panel button lights up. The last received station of the selected band is tuned in.

•Each time you press the button, the band alternates between FM and AM.

FM/AM TUNING

FM / AM

ANALOG	L	R	TUNED STEREO
	SPEAKERS 1		VOLUME
2. Press MEMORY.			MEMORY
ANALOG	L	R	TUNED STEREO
	SPEAKERS 1		VOLUME

The channel number position starts flashing on the display for about 10 seconds.

2. Press TUNING UP 3 or	/REW	PAUSE FF/
TUNING DOWN 2 until		SET
you find the frequency you	DOWN – TUNING – UP
want.

•Pressing TUNING UP 3 increases the frequency.

•Pressing TUNING DOWN 2 decreases the frequency.

Notes:

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

•When an FM stereo program is received, the STEREO indicator also lights up.

•When you hold and then release the button in step 2, the frequency keeps changing until a station is tuned in.

3. Press FM/AM PRESET 5 or ∞ to	FM/AM PRESET
select a channel number while the
channel number position is
flashing.
ANALOG L R	TUNED STEREO
SPEAKERS 1	VOLUME
4. Press MEMORY again while the	MEMORY
selected channel number is
flashing on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

ANALOG	L	R	TUNED	STEREO
	SPEAKERS 1			VOLUME

5.Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one.

27