JVC RX-8020VBK manual Problem

PROBLEM

“OVERLOAD” starts flashing on the display.

POSSIBLE CAUSE	SOLUTION
Speakers are overloaded because of	1.Press STANDBY/ON	on the front panel to
high volume.	turn off the receiver.
	2.Stop the playback source.
	3.Turn on the receiver again, and adjust the volume.
Speakers are overloaded because of	Press STANDBY/ON	on the front panel to turn
short circuit of speaker terminals.	off the receiver, then check the speaker wiring.
	If “OVERLOAD” does not disappear, unplug the AC
	power cord, then plug it back again.

If speaker wiring is not short-circuited, contact your dealer.

The STANDBY lamp lights up after turning on the power, and soon the receiver turns off again (into standby mode).

The receiver is overloaded because of a high voltage.

Press STANDBY/ON on the front panel to turn off the receiver. After unplugging the AC power cord, consult your dealer.

Remote control does not work.

There is an obstruction between the	Remove the obstruction.
remote sensor on the receiver and the
remote control.

Remote control does not work intendedly.

Batteries are weak.

An incorrect remote control operation mode is selected.

Replace batteries. (See page 15.)

Select the correct remote control operation mode. (See pages 51 to 53.)

58