Specifications, Amplifier, Audio, Video | JVC RX-8020VBK specification

Specifications

Amplifier

Output Power:

At Stereo operation:

Front channels:

120 W per channel, min. RMS, driven into 8 Ω, 20 Hz to 20 kHz, with no more than 0.08% total harmonic distortion.

At Surround operation:
Front channels:	100 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no
	more than 0.8% total harmonic distortion.
Center channel:	100 W, min. RMS, driven into 8 Ω at 1 kHz, with no more than
	0.8% total harmonic distortion.
Surround channels:	100 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no
	more than 0.8% total harmonic distortion.

Audio
Audio Input Sensitivity/Impedance (1 kHz):	PHONO (MM):	2.5 mV/47 kΩ
	DVD, VCR 1, VCR 2, VIDEO, TV SOUND/DBS, CD, CDR, TAPE/MD:
		200 mV/47 kΩ
Audio Input (DIGITAL IN)* :	Coaxial: DIGITAL 1 (DVD):	0.5 V(p-p)/75 Ω
	Optical: DIGITAL 2 (CD), DIGITAL 3 (TV), DIGITAL 4 (CDR):
		–21 dBm to –15 dBm (660 nm ±30 nm)
	*Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with
	sampling frequency — 32 kHz, 44.1 kHz, 48 kHz).
	USB: Revision 1.0, full-speed (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz)
Audio Output Level:	PRE OUT	1.0 V
Recording Output Level:	VCR 1, VCR 2, CDR, TAPE/MD:	200 mV
Digital output:	Optical: DIGITAL OUTPUT:	Signal wave length: 660 nm
		Output level: –21 dBm to –15 dBm
Signal-to-Noise Ratio (’66 IHF/’78 IHF):	PHONO:	70 dB/78 dB (at REC OUT)
	DVD, VCR 1, VCR 2, VIDEO, TV SOUND/DBS, CD, CDR, TAPE/MD:
		92 dB/80 dB
Frequency Response (8 Ω):	PHONO:	20 Hz to 20 kHz (±1 dB)
	DVD, VCR 1, VCR 2, VIDEO, TV SOUND/DBS, CD, CDR, TAPE/MD:
		20 Hz to 100 kHz (+1 dB, –3 dB)
	USB:	20 Hz to 20 kHz (+1 dB, –3 dB)
RIAA Phono Equalization:	±1.0 dB (20 Hz to 20 kHz)
Bass boost:	+6 dB ±1.0 dB at 100 Hz
Video
Video Input Sensitivity/Impedance:
Composite video:	DVD, VCR 1, VCR 2, VIDEO, TV SOUND/DBS:		1 V(p-p)/75 Ω
S-video:	DVD, VCR 1, VCR 2, VIDEO, TV SOUND/DBS:
		(Y: luminance):	1 V(p-p)/75 Ω
		(C: chrominance, burst):	0.286 V(p-p)/75 Ω
Component video:	DVD, DBS:	(Y: luminance):	1 V(p-p)/75 Ω
		(PB/PR):	0.7 V(p-p)/75 Ω
Video Output Level:
Composite video:	VCR 1, VCR 2, MONITOR OUT:		1 V(p-p)/75 Ω
S-video:	VCR 1, VCR 2, MONITOR OUT:	(Y: luminance):	1 V(p-p)/75 Ω
		(C: chrominance, burst):	0.286 V(p-p)/75 Ω
Component video:	MONITOR OUT:	(Y: luminance):	1 V(p-p)/75 Ω
		(PB/PR):	0.7 V(p-p)/75 Ω
Synchronization:	Negative
Signal-to-Noise Ratio:	45 dB
On-Screen System:	NTSC

59

Image 62

JVC RX-8020VBK manual Specifications, Amplifier, Audio, Video

Contents

RX-8020VBK Mises en garde, précautions et indications diverses For Canada/pour Le Canada Table of Contents Features Precautions Introduction Display Window Master Volume controlFront Panel STANBY/ON button and Standby lamp Speakers ON/OFF 1 button Remote Control Remote control display window Checking the Supplied Accessories Before InstallationConnecting the FM and AM Antennas Getting Started Best reception Connecting the SpeakersAM Antenna Connections Typical speaker layout Connecting the surround back speakers Basic connecting procedureConnecting the front, center and surround speakers Connecting the subwoofer speaker Analog Connections Connecting Audio/Video ComponentsEnhancing your audio system Audio component connections Cassette deck To audio input To audio output MD recorder Video component connections TV and/or DBS tuner DBS tuner When you connect a DVD player with stereo output jacks DVD player Digital TV DBS tuner Digital ConnectionsYou can connect any digital equipment as follows DVD player CD player Lamp on the USB Audio on the front panel button lights up Change the PC audio settingUSB Connection USB cable Plug the power cord into an AC outlet Connecting the Power CordPutting Batteries in the Remote Control Replace the cover Basic Operations Turning On the PowerBefore using the remote control Selecting the Source to Play Changing the source name Speaker and signal indicators on the displaySpeaker indicators light up Selecting different sources for picture and sound Selecting the Front Speakers Adjusting the VolumeListening Only with Headphones When selecting Dgtl DTS Selecting the Analog or Digital Input ModeWhen selecting Dgtl D.D Dgtl Auto appears on the display Muting the Sound Using the Sleep TimerBasic adjustment auto memory Changing the Display Brightness Basic Settings Basic Procedure Setting the Speakers Feet Select this to set the distance in feet Setting the Speaker DistanceMeasuring unit-UNIT Speaker distance-FRONT DIST, Center Cntr Crossover frequency-CROSSOVER Setting the Bass SoundsSetting the Dynamic Range-MID Night Low frequency effect attenuator-LFE ATT Digital in 1-DVD, MD**, CDR, TV or DBS* or CD Setting the Digital Input Digital in TerminalsSetting the Component Video Input To cancel the One Touch Operation Select this not to store the volume levelTo recall the volume level Source name and Surround/DSP mode appear Tuning into Stations Manually Using Preset Tuning Receiving Radio Broadcasts While listening to an FM station, press FM Mode Press FM/AM Preset 5 or ∞Selecting the FM Reception Mode To tune in a preset station Storing the preset stations Operating the Tuner Using the On-Screen DisplayPress 5 or ∞ to move to an item you want to set or adjust Press 5 or ∞ to move to Tuner CONTROL, then press 2 or Turning Analog Direct On and Off Setting SoundAttenuating the Input Signal Reinforcing the Bass Activating the Subwoofer Sound Dolby Surround Using Surround Modes and DSP ModesReproducing Theater Ambience Introducing the Surround Modes Movie theater At home DVD Multi Playback Mode DTS Digital Surround Early reflections 3D Headphone ModeBehind Direct sounds DTS-ES software Dolby Digital EX software Dolby D EXDolby Digital 5.1-channel software DTS 5.1-channel software DTS Activating the Surround Modes Press Surround to activate Surround modeOn the front panel From the remote control Activating the DSP Modes Press DVD Multi so that DVD Multi appears on the display Using the DVD Multi Playback ModeActivating the DVD Multi Playback Mode Refer also to the manual supplied with the DVD player Adjusting Sound Press 5 or ∞ to move to Sound CONTROL, then press 2 or Adjusting the Equalization Patterns Level Adjusting the Speaker Output LevelsSelect this to adjust the subwoofer Output level ∞ to adjust the speaker output Select a speaker you want to adjustPress Level Adjust repeatedly to Press Control UP 5 or Down Down ∞ to adjust the sound Show Effect Adjust menu seeParameter you want to adjust Press Effect repeatedly to select a Press the play 3 button on the CD player Compu Link Remote Control SystemSame time Functions Text Compu Link Remote Control SystemConnections Operations On-Screen Operating buttons on the remote controlPress Text Display while CD or MD is selected as the source Showing the Disc Information on the TV Screen Then press SET Press Text Display while CD is selected as the sourcePress SET Press SET again Entering the Disc Information Press 5 or ∞ to move To SEARCH, then Press SETPress 5 or ∞ to move To GENRE, then Press SET Press 5 or ∞ to move to the genre you want, then press SET Press Text Display while MD is selected as the sourceEnter the disc title, referring to steps 3 Connections 1 AV Compu Link Connection AV Compu Link Remote Control SystemTo the TV’s Video Input 1 jack using S-video cables Connections 2 Video Cable Connection One-Touch Video Play Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch DVD Play Tuner Operating JVC’s Audio/Video ComponentsOperating Audio Components Sound control section Amplifier CD recorder CD changerTurntable Cassette deck DVD player Operating Video ComponentsVCR 1 VCR connected to the VCR 1 jacks Press and hold TV Press TV/DBS Enter a manufacturer’s code using buttons 1-9,Operating Other Manufacturers’ Video Equipment Release TV Release CATV/DBS Enter manufacturer’s code using buttons 1-9,Press and hold CATV/DBS Press CATV/DBS Control Press and hold VCR1 Press VCR1 Press and hold Audio Press DVD Release Audio Troubleshooting Problem Possible Cause Solution Problem Audio SpecificationsAmplifier Video AM tuner Tuning Range Usable Sensitivity Signal-to-Noise RatioFM tuner IHF General Authorized Service Centers Limited Warranty JVC 0302NHMMDWJEIN Recepteur DE Commande AUDIO/VIDEO Mises en garde, précautions et indications diverses For Canada/pour Le Canada English Introduction Parts Identification STANDBY/ON button and Standby lamp Speakers ON/OFF 1 button Audio Getting Started Connecting the Speakers Basic connecting procedure Left front Right front Speaker Power amplifier Left Right Surround back speakers SUB VCRs C B DVD player CD player USB cable not supplied Connecting the Power Cord Display window on the remote control shows the following LS S RS Adjusting the Volume Always lights up Muting the Sound Setting 2 menu Setting the Speakers Measuring unit-DIST Unit Setting the Bass Sounds Setting the Digital Input Digital in Terminals ONE Touch OPR ONE Touch FL Display Disp Down Tuning UP Analog Tuned Speakers Volume Operating the Tuner Using the On-Screen Display Analog Reinforcing the Bass Using Surround Modes and DSP Modes Playback Dolby Digital EX Neo6 Music DAP Digital Acoustic Processor modes Surround Back Speaker Modes Surround Stereo Headphone To surround left/right channel audio output Adjusting Sound 0dB is the initial setting for each frequency Level Adjust Down ∞ to adjust the speaker Output level -10 dB to +10 dB Show Effect Adjust menu see Compu Link Remote Control System Text Compu Link Remote Control System Down Tuning UP Press Text Display while CD is selected as the source Press 5 or ∞ to move To SEARCH, then Press SET Press Text Display while MD is selected as the source VCR connected to VCR 1 jacks One-Touch Video Play To operate JVC’s audio components using this remote control To start recording again, press this button, then Turn on or off the VCR 1 VCR connected to 10-key will function as Press and hold CATV/DBS Press CATV/DBS Control ∗FRONTL ∗FRONTR Refer to the manuals supplied with your PC On the front panel to Harmonic distortion Per channel, min. RMS, driven into 8 ΩHz to 20 kHz, with no more than 0.08% total MV/47 k Ω FM tuner IHF EN,FR