JVC RX-8020VBK manual English, Problem, Possible Cause, Solution

PROBLEM	POSSIBLE CAUSE	SOLUTION
“OVERLOAD” starts flashing on the	Speakers are overloaded because of	1.Press STANDBY/ON	on the front panel to
display.	high volume.	turn off the receiver.
		2.Stop the playback source.
		3.Turn on the receiver again and adjust the volume.
	Speakers are overloaded because of	Press STANDBY/ON	on the front panel to turn
	short circuit of speaker terminals.	off the receiver, then check the speaker wiring.
		If “OVERLOAD” does not disappear, unplug the AC
		power cord, then plug it back again.
		If speaker wiring is not short-circuited, contact your
		dealer.
The STANDBY lamp lights up after	The receiver is overloaded because of	Press STANDBY/ON	on the front panel to turn
turning on the power, and soon the	high voltage.	off the receiver. After unplugging the AC power
receiver turns off again (into standby		cord, consult your dealer.
mode).
Remote control does not work.	There is an obstruction between the	Remove the obstruction.
	remote sensor on the receiver and the
	remote control.
	Batteries are weak.	Replace batteries. (See page 15.)
Remote control does not work intendedly.	An incorrect remote control operation	Select the correct remote control operation mode.
	mode is selected.	(See pages 51 to 53.)

English

58