ENGLISH
Recording (continued)
Basic Operation
About the TOC
After any recording or editing function, "TOC" (Table Of Contents) is displayed. To finalise the recording or editing function, turn the power off. During this process "TOC" will flash and "TOC EDIT!" will be displayed. During any recording or editing function, the MiniDisc unit lid is locked, and the MiniDisc cannot be removed until the pro- cess is finalised.
Warning:
If the power is removed (Battery/AC adaptor) whilst "TOC" is displayed, the MiniDisc unit lid will remain locked until the battery/main power is restored and the unit is turned on. Your new recordings or edited changes will be lost and your MiniDisc may become unusable.
Caution:
Whilst "TOC" or "TOC EDIT!" is displayed, follow the instructions below.
-Do not jerk or bump the unit.
-Do not unplug the AC adaptor.
-Do not remove the battery.
-Do not subject the unit to shock.
Otherwise, tracks may not be recorded properly.
To prevent recorded MiniDiscs from being
erased accidentally
Slide the accidental erase prevention tab, located on the side of the MiniDisc, in the direction indicated by the arrow.
The MiniDisc will then be protected against accidental erasure.
Recordable 
Recording 
prevented
To add a recording to such a MiniDisc, slide the acciden- tal erase prevention tab back to its original position.
Helpful tip when attaching a label
When attaching a label to an MiniDisc cartridge, be sure to note the following. If the label is not attached properly, the MiniDisc may jam inside the unit and you may not be able to remove it.
If the label peels off or partially lifts away, replace it with a new one.
Do not put a new label on top of an ex- isting one.
Attach the label only in the specified location.
E-13
01/10/11 180H_E_3.fm
