JVC RX-8020VBK manual Adjusting Sound, Press 5 or ∞ to move to Sound CONTROL, then press 2 or

Adjusting Sound

You can adjust sound parameters to your preference after completing basic setting.

•When performing the sound adjustments, it is recommended to use the TV screen so that you can show the on-screen display on the TV.

•When using the buttons on the front panel or remote control without using the on-screen display, you can perform the same adjustments. (The on-screen display cannot be shown.)

•The on-screen display will disappear if no operation is done for about 1 minute.

Basic Procedure

You can also adjust the sound without showing menus on the TV. For details, see each explanation that follows.

Using the on-screen display (through the remote control]:

1. Press MENU.

The MENU screen appears on the TV.

MENU PLAY EXIT

/REW PAUSE FF/

SET

DOWN – TUNING – UP

STOP CONTROL

On-screen operating buttons

2. Press 5 or ∞ to move to “SOUND CONTROL,” then press 2 or 3.

The SOUND CONTROL menu appears.

3.Press 5 or ∞ to move to select “DIGITAL EQ (Equalization),” “LEVEL ADJUST” or “EFFECT ADJUST,” then press 2 or 3.

4.Press 5 or ∞ to move to an item you want to set.

DIGITAL EQ (Equalization) menu (see page 39)

SOUND CONTROL menu

LEVEL ADJUST menu (see page 40)

EFFECT ADJUST menu (see page 42)

5.Press 2 or 3 to adjust a sound parameter.

6.When you finish, press EXIT repeatedly until the menu disappears from the TV.

•If Analog Direct is in use, you cannot make any sound adjustments.

•Above items shown on the on-screen display are initial values when shipped from the factory.

•Some of the items cannot be shown or cannot be adjusted. (For details, see the respective explanation in this section.)

38