JVC RX-8020VBK manual English, Adjusting the Sound Parameters for the

Adjusting the Sound Parameters for the

Surround and DSP Modes—EFFECT ADJUST

You can adjust the Surround and DSP sound parameters to your preference.

•Once you have made adjustment, it is memorized for each source.

7Adjustable parameters

You can adjust the following parameters:

For Surround, DAP, JVC Theater Surround and All Channel Stereo modes (when the center speaker is connected)

CENTER TONE	: Adjust the center tone. As the number
(CTR TONE)	increases, the dialogue becomes clearer so
	that the human voices change from soft to
	sharp. (Normally select “3.” Adjustable range:
	1 to 5)

For DAP modes and JVC Theater Surround

EFFECT LEVEL : Adjust the DAP effect level. As the

(EFFECT) number increases, the DAP effect becomes stronger. (Normally select “3.” Adjustable range: 1 to 5)

ROOM SIZE	: Adjust the virtual room size. As the
(ROOMSIZE)	number increases, the interval between
	reflections increases so that you will feel
	as if you were in a larger room. (Normally
	select “3.” Adjustable range: 1 to 5)
LIVENESS	: Adjust the liveness effect. As the number
	increases, the attenuation level of
	reflections over time decreases so that
	acoustics change from “Dead” to “Live.”
	(Normally select “3.” Adjustable range: 1 to 5)

Note:

You can only adjust the Effect Level when using a DAP mode with

the 3D-PHONIC indicator lights up.

For Pro Logic II Music only

PANORAMA	: Select “ON” to add “wraparound” sound
(PNRAMA)	effect with side-wall image. (Initial
control	setting: “OFF”)

CENTER WIDTH : Adjust the center channel localization

(CWIDTH) between the center speaker and the left/ right speakers. As the number increases, the center channel sound moves toward the left and right speakers. (Normally select “3.” Adjustable range: OFF and 1 to 7)

DIMENSION	: Adjust sound localization position. As the
	number increases, the sound localization
	moves towards forward from backward.
	(Normally select “4.” Adjustable range: 1 to 7)

Using the on-screen display (through the remote control]:

1. Show EFFECT ADJUST menu (see page 38).

Parameters that are not adjustable for the currently selected Surround and DSP modes are skipped.

2.Press 5 or ∞ to move to a parameter you want to adjust.

3.Press 2 or 3 to adjust the parameter.

4.Repeat steps 2 and 3 to adjust the other parameters.

5.When you finish, press EXIT repeatedly until the menu disappears from the TV.

On the front panel:

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1. Press EFFECT repeatedly to select a	EFFECT SETT
parameter you want to adjust.

•Each time you press the button, the items change as follows:

EFFECT = ROOMSIZE = LIVENESS =

CTR (center) TONE = PNRAMA (Panorama) =

C (center) WIDTH = DIMENSION =

(Back to the beginning)

Parameters that are not adjustable for the currently selected Surround and DSP modes are skipped.

2. Press CONTROL UP 5 or	CONTROL
	DOWN UP
DOWN ∞ to adjust the sound
parameter.

3.Repeat steps 1 and 2 to adjust the other parameters.

English

Note:

Parameters that are not adjustable for the currently selected Surround

and DSP modes are skipped.

42