Power Supply
Mains Operation
Only use a mainsYunit with the correct output voltage of 9V = and cor-
rect polarity .
Connect the mains unit to the DC 9V socket. This disconnects the inserted batteries.
No responsibility can be accepted for damage due to incorrect mains operation.
Remove the batteries if you intend to operate the unit permanent- ly on the mains!
Battery Operation
with six 1.5 Volt batteries, type IEC LR 6 /
We recommend the use of
Disconnect the plug of the mains unit from the DC 9V socket.
Open the cover of the battery compartment (at back of unit).
Insert batteries with correct polarity (see scheme above battery com- partment).
Observe correct order of batteries when fitting them.
Battery Check
When the batteries get weak, the indication BATT. CHECK will flash in the display.
When the radio is switched on, it will switch off after a short time.
TIME I
8 6:3 | 0 | : | |
|
|
| |
| BATT. CHECK | 8.I.8.0.0 | |
|
| ||
|
|
| 0 0 |
Attention
Remove exhausted batteries immediately from the unit!
If the unit is not to be used for long periods, also remove new batte- ries!
No responsibility can be accepted for damage caused by leaking bat- teries.
Protect the Environment!
Do not throw exhausted batteries in the household waste!
When buying new batteries, hand over the old ones to your radio dealer or a special collecting point.
k11
