![](/images/new-backgrounds/1231246/23124677x1.webp)
UsingtheSetupMenu
NOTE
•Performing a new channel search will erase and replace all previously stored channels.
3 MODIFY CHANNEL INFORMATION
(If there is no captured channel, this feature is not available.)
or
button.
The information of the current channel will show on the screen.
Editing the channel name
1Press ENTER button after selecting “Name” by using ![](/images/new-backgrounds/1231246/23124677xi7.webp)
or![](/images/new-backgrounds/1231246/23124677xi9.webp)
![](/images/new-backgrounds/1231246/23124677xi10.webp)
button.
The keyboard will show on the screen.
2Select a letter which you want to input by using
,
,
,
button, and press ENTER button to confirm it.
3Repeat step 2.
The maximum length of the channel name is up to 5 characters.
4The control bars of the last line in the keyboard is for edit command.
If the inputting of letters is finished, press ENTER button after selecting “OK”.
Frequency
If the captured signal is bad, you can search the channel again.
1Select “Frequency” by using or
button.
2Press or
button, and it starts to search channels automatically.
If the broadcasting is found during searching, it stops to search.
If you want to stop searching, press STOP button.
Sound system
Set the sound system used for the current channel.
1Select “Sound system” by using or
button, and press ENTER button.
2Select the sound system by using or
button, and press ENTER button.
Skip
If you want to skip a captured channel, select “Yes”.
Fine tune
If the captured signal is not good, you can tune the channel fine.
1Select “Fine tune” by using or
button.
2Tune the channel fine by pressing
or
button.
Each time or
button is pressed, the channel frequency decreases or increases by 50KHz.
button if all the settings are correct.
Using the Setup Menu 39