Installation Procedure
Connect the wires of swing flap motor on the ornament panel.
Connect the signal wires.
Check if the remote controlling is avalible, if not,please check if all the connecting of wires is right.Turn off the power for ten seconds,and then try it again.
remote receiver
Electrical box
Emergency switch
Pay special care to the following and check after installation
Item to the checked
Unproper installation may cause
Check
Is indoor unit firmly installed? | Unit might fall down, make vibration or noise. |
|
|
|
|
Is gas leakage check performed? | This may lead to gas shortage. |
|
|
|
|
Is unit properly insulated? | Dew or water drop may occur. |
|
|
|
|
Is water drainage smooth? | Dew or water drop may occur. |
|
|
|
|
Is power voltage meet that stipulated on the nameplate? | Problem may occur or parts got burned. |
|
|
|
|
Is wiring and piping correctly arranged? | Problem may occur or parts got burned. |
|
|
|
|
Is unit safely grounded? | There might be a danger of electric shock. |
|
|
|
|
Is wire size correct? | Problem may occur or parts got burned. |
|
|
|
|
Are there any obstacles on air inlet and outlet grill of | This may cause poor cooling. |
|
indoor and outdoor unit? |
|
|
|
|
|
Is record made for piping length and refrigerant | It is hard to control refrigerant charging |
|
charging amount? | amount. |
|
|
|
|
22
