English
installing your refrigerator
Unpacking Your Refrigerator
1.Remove all packaging material. This includes the foam base and all adhesive tape holding the refrigerator accessories inside and outside.
2.Inspect and remove any remains of packing, tape or printed materials before powering on the refrigerator.
CAUTION
Risk of Fire or Explosion due to puncture refrigerant tubing. Flammable refriger- ant used. Handle with care when moving refrigerator to avoid either damaging the refrigerant tubing or increasing the risk of a leak.
Leveling Your Refrigerator
•Your refrigerator has two leveling legs which are located in the front bottom corners of your refrigerator. After properly placing your
refrigerator in its final position, you can level your refrigerator.
•Leveling legs can be adjusted by turning them counterclockwise to raise your refrigerator or by turning them clockwise to lower your refrigerator. The refrigerator door will close easier when the leveling legs are extended.
Proper Air Circulation
•To ensure your refrigerator works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation, plumbing and electrical connections.
•The following are recommended clearances around the refrigerator:
Sides……………4" Top..................4" Back.................4"
Door Alignment
1. Remove the top hinge cover by using a flathead screwdriver. Place the head under the front edge of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips | fig. 1 |
head screw driver. |
|
3.Adjust the door or put a spacer in between and tighten the screws.
4.Replace the top hinge cover by aligning the rear of the cover with the rear of the hinge. Press firmly on the front of the cover until it snaps in place.
5
