Parts
17.SLEEP Button
(The clock must be corrected before setting sleep function)
Used to set sleep mode.
The distance between the remote controller and the receiver should be max 7m and there should be no obstacle between them.
Do not throw the remote controller; prevent it from being damaged.
18.FAN Button
Used to select fan speed:LOW,MID,HIGH,AUTO.
19.TIMER OFF Display 20.TIMER Display 21.FILTER Display
When the filter need be cleaned, the sign will appear automatically.
22.TEMPERATURE Display 23.AUTO SWING Display 24.HIGN/SO Run Display
25.Code A display
Code A is used for this unit
26.SIGNAL SENDING Display 27.Code B display
28.Fresh Display
29.Auxiliary ELECTRICAL HEATING Display 30.HEALTH Display
Displays when healthy run function is set.
31.Operation MODE Display
AUTO RUN COOL RUN DRY RUN HEAT RUN FAN RUN
32.SLEEP State Display 33.BATTERY Energy Display
Notify the user when it is time to change the batteries.
34.LOCK State Display 35.FAN SPEED Display
A
U
T
O
AUTO LOW MED HIGH
36.TIMER ON Display
Remote Controller Operation
When in use, direct signal transmission head to the receiver placed on the indoor unit
When operating the remote controller in an area where electronically controlled lights are installed or wireless handsets are used, please move closer to the indoor unit as the function of the remote controller might be affected by signals emitted by the above mentioned equipments.
Battery loading
Battery loading
Batteries are fitted as follows: |
| + |
- | - | |
Remove the battery compartment lid |
| + |
Slightly press and disengage the battery compartment lid marked with ìî and then hold the remote controller by the upper section and then remove the battery compartment lid by pressing in the direction of the arrow as shown in the figure above.
Loading the battery
Ensure that batteries are correctly placed in the compartment as required for positive and negative terminals.
Replacing the battery compartment lid
The battery compartment lid is reinstalled in the reverse sequence.
Display review
Press the button to see if batteries are properly fitted. If no display appears, refit the batteries.
Confirmation indicator
If no indication is displayed after press ON/OFF button, reload the batteries.
Caution:
If the remote controller does not operate as designed after fitting new batteries of the same
type, press the Reset button (marked ) with a pointed article.
Note:
It is recommended that the batteries be removed from the compartment if the remote controller is not used for an extended period.
The remote controller is programmed for automatic test of operation mode after the batteries are replaced. When the test is conducted, all icons will appear on the screen and then disappear if the batteries are properly fitted.
When throw away the waste batteries,please perform in accordance with the local regulation.
Clock Set
When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows:
1.Press CLOCK button, clock indication of " AM " or " PM " flashes. 2.Press or to set correct time. Each press will increase or decrease
1 min. If the button is kept pressed, time will increase or decrease quickly. 3.After time setting is confirmed, press "SET" : AM or PM stop flashing,
while clock starts working.
Note:AM means morning and PM means afternoon.
MODESLEEP
HEALTH FRESH
CLOCK |
| SET |
1 TIMER | 2 | HIGH/SO 3 |
FILTER |
| HEAT |
RESET CODE | LIGHT | LOCK |
5