Operation
Dry Operation
Display panel
Remote controller
1. Unit start
Link with electronic power.
Press ON/OFF on the remote controller, unit starts.
The liquid crystal will display the working state of las time (Except Timer, Sleep, Power/Soft and Health airflow).
2.Select operation mode
Press MODE button. For each press, operation mode changes as follows:
Remote controller:
| AUTO | COOL | DRY | FAN | HEAT |
|
Then
Select DRY operation
3.Select temp.setting Press TEMP. button
Every time the button is pressed, temp.setting increase 1 C,if kept depressed, it will increase rapidly
Every time the button is pressed, temp.setting increase 1 C,if kept depressed, it will decrease rapidly
Select a desired temperature.
COOL operation starts when room
temp.is higher than temp.setting.
Temp.seting+2oC
Tmpe.sting
On reaching temp.setting +2oC unit will run in mild DRY mode.
4.Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
| LOW | MED | IH | AUTO |
|
Air conditioner is running under displayed fan speed In DRY mode, when room temperature becomes 2oC
higher than temp.setting,unit will run intermittently at LOW speed regardless of FAN setting.
5.Unit stop
Press ON/OFF button, the unit stops.
11