Haier HTWR10VCK, HTWR12VCK, HTWR08XCK, HTWR12XCK, HTWR10XCK manual Installation Instructions, 76 8

INSTALLATION INSTRUCTIONS

CAUTION

There are sharp edges that can cause serious cuts.

When lifting the air conditioner,it is HEAVY. Use 2 peoples to lift.

For New Construction install Haier Wall Sleeve.

Remove old air conditioner and inspect sleeve for the following: Insallation--Make sure that sleeve is securely installed and in sound structural condition.

Dimensions--Measure the size to make sure the air conditioner ZLOO¿W

Slope--There should be a rearward slope for condensate to drain from the rear of the sleeve.

Chece against Fig.A.

to

Wall Sleeve

Number	Part name	QTY.
1	Wide Top/Bottom Trim Frame	2
2	Wide Side Trim Frame	2
3	Narrow Top/Bottom Trim Frame	2
4	Narrow Side Trim Frame	2
5	Foam Seal	1
6	Universal Fit Rear Grille	1
7	Screw	4
8	Washer	4
9	Tapered Spacer Block	2
10	Board	1

REAR

FRONT

How to install

UNIT LEVEL

Fig.A

Manufacturer--So the method of installation can be determined. If the installation and slope are suspect,then removal and correct installation of a Haier Wall Sleeve,is recommended.

Check the conetents of the accessories supplied with your air conditioner as shown below:

7 6

8

9 10

1

5

4

2

3

1.Identify the existing wall sleeve before installing the unit from the listed below.

Brand	Wall Sleeve Dimensions(inches)
	Width	Height	Depth
Haier Amana	25-13/32	15-3/4	17-1/2
Haier Amana	25-7/8	15-9/16	16-3/4
White-westinghouse			16,17-1/2
Frigidaire	25-1/2	15-1/4
			or 22
Carrier(52F series)
General Electric /Hotpoint	26	15-5/8	16-7/8
Whirlpool	25-7/8	16-1/2	17-1/8
Fedders/Emerson	27	16-3/4	16-3/4
			or 19-3/4
Sears/Kenmore	25-7/8	15-17/32	16-23/32
Carrier(51S series)	25-3/4	16-7/8	18-5/8
Emerson/Fedders	26-3/4	15-3/4	15
Friedrich	27	16-3/4	16-3/4
LG	25-7/8	15-17/32	16-23/32

Note:All wall sleeves used to mount the new Air Conditioner must be in sound structural condition and have a rear grille WKDWVHFXUHO\DWWDFKHVWRVOHHYHRUUHDUÀDQJHWKDWVHUYHVDVD stop for the Air conditioner.

2.Clean the interior of the sleeve (do not disturb seals). 3.Repaint the sleeve if needed.

4.On 25 13/32”-26”sleeves:Replace the existing louvered grille with the new one supplied in the package,shown in the Fig.B

4