Haier HTWR08XCK, HTWR12VCK manual Airconditioneruse, StartingYourAirConditioner, Mode, Fan Speed

AIRCONDITIONERUSE

Operating your air conditioner properly helps you to obtain the best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

ʄIf you turn off the air conditioner, wait at least 3 minutes before turning it back on. This keeps the air conditioner from blowing a fuse or tripping a circuit breaker.

ʄDo not try to operate your air conditioner in the Cool mode when outside temperature is below 61°F (16°C). The inside evaporator coil will freeze up, and the air conditioner will not operate properly.

StartingYourAirConditioner

MODE	SPEED	TIMER	RESET	TEMP/TIME
FAN	HIGH	ON	CHECK
			FILTER
COOL	MED	OFF
ENERGY	LOW			POWER
SAVER				ON/OFF
DEHUM

5HPRYHWKHFOHDUSODVWLF¿OPIURPWKHFRQWUROSDQHO

2.Press POWER to turn on the air conditioner. The Power indicator light will turn on.

POWER

ON/OFF

ʄEnergy Saver—Fan runs only when cooling is needed. Press SPEED to select High, Med or Low fan speed.

Because the fan does not circulate the room air continuously, less energy is used, but the room air is not circulated as often.

ʄDehum—Dries the room. The air conditioner automatically selects the temperature.

NOTE:

ʄDehum mode should not be used to cool the room.

ʄIn Dehum mode,Please do not operate the speed button.

MODE

FAN

COOL

ENERGY

SAVER

DEHUM

NOTE: When the air conditioner is plugged in, the LED display will show “88” for 3 seconds. After the air conditioner is turned on for WKH¿UVWWLPHWKHGLVSOD\ZLOOVKRZWKHFXUUHQWURRPWHPSHUDWXUH and the fan is set to Low speed.

After the unit is plugged in, but before the unit is turned on, press and hold the POWER button for 5 seconds to switch the temperature display between Fahrenheit (F) and Celsius(C) degrees.

3.Select mode. See “Mode.”

4.Select fan speed. See “Fan Speed.”

5.Set temperature. See “Temperature.”

Mode

1.Press MODE until you see the indicator light glow for the desired setting.

2.Choose Fan, Cool, Energy Saver or Dehum.

ʄFan—Only the fan runs. Press SPEED to select High, Med or Low fan speed. The display shows the current room temperature.

ʄCool—Cools the room. Press SPEED to select High, Med or Low fan speed. Press the TEMP/TIME up or down

arrow button to adjust the temperature.

Fan Speed

1.Press FAN SPEED until you see the indicator light glow for the desired setting.

2.Choose High, Med or Low.

Ŷ+LJK IRUPD[LPXPFRROLQJ Ŷ0HG IRUQRUPDOFRROLQJ Ŷ/RZ IRUPLQLPXPFRROLQJ

SPEED

HIGH

MED

LOW

6