Haier HTWR12VCK Depth“D” of the, Length“A”, existing wall, sleeveinches, 20 D, 205 8 D, Front

Fig.B

Mounting tabs can be bent or cut off if not needed.Please use the correct holes to match the sleeve.

On 26 3/4”-27” sleeves:Use existing rear grille and redirect louvers

to 60 angle as shown in Fig.C

Fig.C

5.If the depth of your existing wall sleeve is less than or equal WR´VNLSWRVWHS2WKHUZLVHFXWWKHEDIÀHVDQGWKHVXSSRUW blocks according to length“A” in the table below.

Depth“D” of the	Length“A”	A
existing wall
	（inches）
sleeve(inches)
20<D<205 8	3 4		A
205 8<D<213 4	1- 3 4
213 4<D<24	4			Fig.D

6.Remove the backing from the support blocks and attach them to the inside of the wall sleeve as shown FIG E.Slide the

EDIÀHLQWRVROWVRIWKHVXSSRUWEORFNV

7.Install the new unit into the wall sleeve.

8.Install the 1”x1 1/2”x84”long stuffer seal between the wall sleeve and the unit.

9.To assemble trim,snap the tab of each piece into the slot of the other piece as shown below.2-Trim frames are supplied ZLWKXQLWXVHWKHWULPIUDPHWKDWEHVW¿WV\RXUVOHHYH 6OLGHWULPRYHUWKHIURQWRIWKHDLUFRQGLWLRQHUXQWLOWULPLVÀXVK with sleeve as shown below.

Assemble Trim

Fig.F

Note:Be sure to route the cord through the trim frame before placing the trim frame on the unit.

Wall

Sleeve

Wall

FRONT

6	1
	2	”

Tapered Spacer

Block Board

Tapered Spacer

Block

Fig.E

5