Haier HWE12XCN, HWE10XCN, HWE08XCN, HWE06XCN STARTING THE AIR CONDITIONER cont, Mode, English

ENGLISH

STARTING THE AIR CONDITIONER cont.

1.Carefully remove the clear plastic film from the control panel.

2.Press POWER once to turn on the air conditioner.

NOTE: When the air conditioner is first plugged in, the LED display will show “88” for 3 seconds. After the air conditioner is turned on for the first time, the display will show the temperature 72°F and the fan is automatically set to Low speed and the Mode indicator will show ENERGY SAVE.

NOTE: To switch the temperature display between Fahrenheit (F) and Celsius(C), the air conditioner must be plugged in, and turned ON. On the control panel on the front of the AC, press the UP and DOWN button at the same time and hold for 3 seconds. The change cannot be done using the remote control.

3.Select Mode. Refer to “Mode.”

4.Select Speed. Refer to “Speed.”

5.Set Timer. Refer to “Temp/Time”

6.Reset the filter. Refer to “Filter Reset”

MODE

1.Press mode until you see the indicator light come on next to the desired setting.

2.Choose Fan, Energy Save, Cool or Dehum.

FAN―Only the fan runs. Press SPEED to select High, Med or Low fan speed. The display shows the current room temperature.

ENERGY SAVE―In this mode the fan runs only when cooling is needed. The fan will run for 3 minute after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the temperature in the room is above the set temperature. The compressor then turns back on.

COOL―Cools the room. Press SPEED to select High,Med , Low or Auto Cool fan speed. Press the TEMP/TIME up or down arrow button to adjust the temperature.

DEHUM―Aids in removing humidity from the room. This setting will NOT cool the room.

NOTE:

•Dehum mode cannot be used to cool the room.

USING YOUR AIR CONDITIONER PAGE 15