USB HomeBase

USB Connector

Power Supply

Connector

Rear View of Dolphin USB HomeBase

There is a 5V DC power supply connector and a USB connector:

Power supply connector Use this connector to attach a power supply to the HomeBase. The power supply provides 5V DC input for communications and battery charging.

USB Communications Port Use a USB full-speed detachable cable to connect this downstream device port to an upstream USB Host or Hub. The USB HomeBase is USB 1.3 compliant.

Bottom Panel of HomeBase/IntelliBase/IntelliBase+

A Baud Rate switch used to select the communication baud rate is located on the bottom of the HomeBase, IntelliBase and IntelliBase+. The Baud Rate Switch on the HomeBase is a three-position switch; four-position on the IntelliBase and IntelliBase+. Switch position and the corresponding baud rates are shown in the charts below.

The USB HomeBase does not require a baud rate switch.

6 - 6

Page 60
Image 60
Hand Held Products 7400/7450 manual USB HomeBase, Bottom Panel of HomeBase/IntelliBase/IntelliBase+