Hand Held Products 7400/7450 manual Bottom Panel of Mobile IntelliBase/Mobile Base

Bottom Panel of Mobile IntelliBase/Mobile Base

A four-position Baud Rate switch, located on the bottom of the Mobile IntelliBase, is used to select the communication baud rate. Switch positions and the corresponding baud rates are shown in the chart below.

Baud Rate Table For Connecting To PCs

Baud Rate	Switch 1		Switch 2	Switch 3	Switch 4
115200	OFF		ON	ON	ON
57600	ON		OFF	OFF	ON
38400	ON		OFF	ON	ON
19200	ON		ON	OFF	ON
9600	ON		ON	ON	ON
		Baud Rate Table For Connecting To Modems
Baud Rate	Switch 1		Switch 2	Switch 3	Switch 4
115200	OFF		ON	ON	OFF
57600	ON		OFF	OFF	OFF
38400	ON		OFF	ON	OFF
19200	ON		ON	OFF	OFF
9600	ON		ON	ON	OFF

Powering the Dolphin Terminal

When seated in the Mobile IntelliBase/Mobile Base, the Dolphin terminal receives the power it needs to charge the battery and to run its internal circuitry.

The Dolphin terminal can be stored indefinitely in the charging/communication without damage to the terminal or the Mobile IntelliBase/Mobile Base. Keep the mobile charging/communications cradle plugged in so that the Dolphin terminal battery pack stays fully charged.

Charging A Dolphin Terminal

The Mobile IntelliBase/Mobile Base supplies charging power to the Dolphin terminal so that the terminal can monitor the charging of its battery pack. This charging method protects the battery from being damaged by overcharging. Therefore, the Dolphin terminal may be stored indefinitely in the Mobile IntelliBase/Mobile Base without damage to the terminal, the battery pack, or the Mobile IntelliBase/Mobile Base.

To charge a Dolphin terminal, follow these steps:

1.Insert a battery pack into the Dolphin terminal.

2.Place the terminal, imager engine window up and the LCD visible, in the terminal well of the Mobile IntelliBase/Mobile Base.

3.Let it glide down into the well until it stops.

4.Once the Dolphin terminal is properly seated, the Dock LED on the Mobile IntelliBase/Mobile Base will be solid GREEN.

Deep-Cycling Batteries

For maximum battery life, HHP recommends that you deep-cycle (service) the battery twice before initial use and once a month thereafter. Since the Dolphin 7400 Mobile Intellibase and Mobile Base do not have deep-cycling capabilities, it is recommended that you use the Battery Conditioning Utility software, the IntelliBase+ or a Dolphin QuadBattery Charger. See the Battery Management section in Chapter 3 for more information.

8 - 6