Hand Held Products 7400/7450 manual Description, Status LED

Models: 7400/7450

1 107
Download 107 pages 44.79 Kb
Page 73
Image 73

The LEDs indicate the charging status of batteries as described in the chart shown on the next page:

Status LED

Description

Green

Charging is complete and battery is ready for service.

Orange

Battery is being charged at a maximum charge rate

Red

Error was encountered during charge cycle

Status of LEDs during Charging Cycle

To remove a battery pack, push the locking tab down and pull the battery out from the charging pocket with a hinging motion.

Servicing The Battery Pack

To service battery packs, insert batteries into the charging pockets and press the Condition button. The Condition LED will flash during the conditioning cycle. This starts an automatic process in which batteries are completely discharged and then recharged to full capacity in eight hours. The Condition and Calibrate cycle resets and calibrates battery data so that the user gets longer, more consistent performance from the batteries. HHP recommends that battery packs should be serviced, or calibrated, once a month.

Because the Dolphin QuadCharger is accumulating battery pack information during the entire Condition and Calibrate cycle, it is important not to remove the battery until the cycle has been completed and the Condition LED is no longer flashing. Batteries inserted after the “Condition and Calibrate” switch has been depressed will receive a standard charge. The chart below describes the Status LEDs during the Condition and Calibrate cycle:

Status LED

Description

 

 

 

Cycle is complete. Battery

Solid Green

remains in trickle charge until

 

removed from the charger.

 

 

Flashing Orange

Battery is being conditioned

 

 

Solid Red

Error was encountered during

 

charge cycle

 

 

Status of LEDs during Condition and Calibrate Cycle

Storing Batteries

To maintain top performance from batteries, follow the guidelines below when storing them:

Avoid storing batteries outside of the specified temperature range of -4 to 104° F ( -20 to 40°C) or in extremely high humidity.

For prolonged storage, do not keep batteries stored in a charger that is connected to a power source.

During long-term storage, battery deactivation may tend to occur which may cause charging to stop early during recharging after storage. This issue can be handled by charging and discharging the battery several times. Also, the first charging after prolonged storage may yield a lower than normal capacity. While this will vary depending on the storage conditions, charging and discharging the battery several times will almost completely restore capacity.

7 - 3

Page 73
Image 73
Hand Held Products 7400/7450 manual Description, Status LED