Rear Panel
Communications Port | Power Supply Connector |
Rear Panel of Dolphin 7400/7450 Quad Charger
Power Supply Connector
Use this connector to attach the power supply to the QuadCharger. The universal power supply accepts input voltages between
Communications Port
The communications port is for factory use only in programming the QuadCharger.
Charging Batteries In The QuadCharger
Follow these steps to charge batteries in the QuadCharger:
1.Set up the charger for use
2.Supply power
3.Insert batteries
CAUTION: Do not attempt to recharge any battery pack in the Dolphin 7400/7450 QuadCharger that is not manufactured by HHP especially for this device. To do so will void your warranty and could damage the Dolphin 7400/7450 QuadCharger.
Setting Up The QuadCharger
The Dolphin QuadCharger should be set up on any dry, stable surface. DIN rail slots on the bottom panel allow the charger to be wall or
The charger must be connected to a power source for any type of operation.
Supplying Power To The QuadCharger
CAUTION: Using a
Locate the AC power cord that came with the Dolphin QuadCharger. Plug the cord into the power supply connector on the back of the unit and then plug the power cord into a wall socket.
Press and hold the Power Switch for approximately one second, then release, to turn on the Dolphin 7400 QuadCharger. The GREEN power LED will illuminate and the charger will undergo a
Inserting and Removing Battery Packs
To insert a battery pack, place the end of the battery without the locking tab into the bottom of the charging pocket and snap the battery into place with a hinging motion. Once the battery is properly seated, the orange status LED for that particular pocket will illuminate.
For best results, battery packs should be at room temperature before recharging them; temperature has a marked effect on charging. The recommended temperature range is 50° to 95° F (10° to 35° C).
7 - 2
