Terminal Setup
Quick St
d the Hand Held
initial serial download,
the terminal software and configuration are m naged automatically over the wireless
network.
Software Management section before
proceeding.

Configuring the Manager

The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.

Setting the Emulation

Click on Start, Programs, PowerNet, and Twin Client Manager. Select the S
art
This section describes how to prepare the Twin Client Manager an
Products terminal for a Telnet session with the host. Following an
a
Note: Hand Held Products terminals are normally delivered with Hand Held Products
files pre-installed. However, if the terminal does not have those files installed,
refer to instructions at the end of the
ettings
menu as shown below.
Click on Emulation, select the desired emulation, and click on OK.
Supported Equipment Manual
•
January, 2006 2-5