Terminal Setup
Setting the Segment Checking the Segment button restricts a terminal group to a range of IP addresses. The
only to identify the
egment. The setting of the Net Mask can be used to restrict the range. This feature is
seful for segregating terminal groups by location.
Clicking on the F
IP Address can be any valid address on the segment, as it is used
s
u
Setting Force Reload orce Reload button forces all terminals within a group to be
automatically updated. The following warning message appears.
Click on the Yes button to force the reload.
Setting the Default Terminal Group New terminals that have not yet been assigned to any group are initially assigned to the
default group in effect when they are cold booted.
Any group can be made the default group by clicking on the group, and then clicking on
the right mouse button. Then click on the Make Default option.
Reassigning Terminals After a terminal has been configured and assigned to the default group, it can be
reassigned to a new group by clicking on the terminal icon as shown below.
Then, holding the mouse button down, drag the terminal icon to the desired group.
2-32 Supported Equipment Manual
•
January, 2006