Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
To prevent serious injury
from accidental operation:
Turn the Power Switch (46) of the Lathe to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments.
PRODUCT FEATURES
BALANCE | HEADSTOCK | FIGURE A | (5) | ||||
(22) | (14) |
| |||||
| WHEEL | SPINDLE |
|
|
| TAILSTOCK | |
| BACK | HEADSTOCK | LOCK | ||||
| LID | LEVER | |||||
| SPUR |
|
|
| |||
(20) |
|
|
| (6) | |||
CENTER | |||||||
|
| (12) |
|
|
|
| |
|
|
| TOOL |
| |||
|
|
| REST |
| |||
|
| (35) |
|
|
| ||
|
|
|
| CUP | TAILSTOCK | ||
|
|
|
| CENTER | |||
|
|
|
| (11) |
| HANDWHEEL | |
|
|
|
| ||||
|
|
|
|
|
|
| (4) |
|
|
| SWITCH |
| |||
|
|
|
|
| |||
|
| BED |
| ||||
| BED | (1) | (46) |
|
|
| |
|
|
|
|
SLIDE
LID (63)
ASSEMBLY Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.The Lathe comes fully assembled with the exception of the Tool Rest (35). To install the Tool Rest, loosen the Lock Lever (41). Insert the Tool Rest into the Tool Rest Base (36). Then retighten the Lock Lever to se- cure the Tool Rest in place.
(See Figure B.)
TOOL REST |
|
|
| |
BASE | TOOL REST | FIGURE B | ||
(36) | ||||
(35) | ||||
|
|
| ||
|
|
| LOCK LEVER | |
|
|
| ||
|
|
| (41) | |
|
|
|
|
Work Area Set Up
1.Designate a work area that is clean and
SKU 65345 | For technical questions, please call | Page 9 |