Harbor Freight Tools 92966 Setup and Adjustment Section Contents, Mounting the Bobbin Winder

Mounting the Bobbin Winder

Note: Unless indicated otherwise, all parts referred to in this set of instructions are listed in the Bobbin Winder & Thread Stand Unit Parts List found on page 23. During assembly, it will be helpful to refer to that list and the diagram above it on the same page.

20.Remove the Belt Cover (part 8-27, on page 21). Swing the sewing machine so the base is in the operating position, resting on the table. Set the Bobbin Winder to the ‘ON’ Position-see ON Position, below.

21.Make sure the Bobbin Winder is in the ‘ON’ position. Position the Base (Bobbin Winder Base Assembly) (10-1) so that the Thread Winder Assembly (10-4) lines up with and just touches the belt. Mark pilot hole locations on the table at the far end of each of the two channels in the Base as indicated in Figure A.

22.Set the Base (10-1) aside and swing the sewing machine out of the way. Carefully drill straight pilot holes for each of the two locations marked above. Place the base in location and secure using two Wood Screws (10-22) and Washers (10-23). Leave the Screws just loose enough to allow the Base to slide.

Figure A

Mark

Pilot

Holes

Here.

Figure B

23.Swing the Sewing Machine back into it’s operating position. Put the Bobbin Winder in the ‘OFF’ position-see OFF Position, below. Slide the Bobbin Winder Assembly close to

the belt until it just barely doesn’t touch it (1/8” gap or less)-see Figure B, above. Tighten the Wood Screws (10-22) from step 22, above.

24.Put the Belt Cover back on the Sewing Machine before use.

	Setup and Adjustment Section Contents
Section		pAge
Bobbin Winder Operation		9
Setting Bobbin in Case		9
Needle Attachment	............................................................................................................	10
Threading the Machine		10
Stitch Length		11
Reversing Sewing Direction		11
Needle Thread Tension		11
Bobbin Thread Tension		11
Thread Take-up Spring		11
Thread Take-up Stroke		12
Presser Foot Pressure		12
Presser Bar Height		12
Feed Timing		12
Feed Dog Height		13
Needle-to-hook Timing		13
SKU 92966	For technical questions, please call 1-800-444-3353.	Page