8.Point the Sandblasting Gun at the workpiece so that the media will strike the surface of the workpiece at about a 45 degree angle.
9.Squeeze the Control Lever (34) of the Sandblasting Gun to release the media. NOTE: The flow rate of the media may be irregular when the Sandblasting Gun is first started. Provided the media is dry, the flow rate will become normal in approximately one minute. (See Figure G.)
10.Adjust the Media Metering Valve (18) to increase or decrease the media flow rate. (See Figure G.)
11.Adjust the Air Input Valve (14) to regulate the total air flow and pressure at the Sandblasting Gun. (See Figure G.)
12.Move the Sandblasting Gun in a circular or right to left motion until you have achieved the desired appearance (finish) on the workpiece.
13.Periodically, check the Water Trap (12) for excessive water
the bottom of the Water Trap to drain the water. (See Figure G.)
14.When the sandblasting job is completed, release pressure on the Control Lever (34) of the Sandblasting Gun. Turn off the air compressor. Turn the Media Metering Valve (18) and Air Input Valve (14) to the “OFF” position.
(See Figure G.)
15.Use the Safety Valve (6) to release any remaining air pressure in the Tank Assembly (3). Check to make sure the Pressure Gauge reads “0” PSI. (See Figure G.)
16.Squeeze the Control Lever (34) of the Sandblasting Gun to release any remaining air pressure and media. (See Figure G.)
17.Disconnect the compressor air hose from the Quick Connector on the Pressure Blasting System. (See Figure F.)
18.If necessary, empty the Tank Assembly (3) of any remaining media. Then, store the Pressure Blasting System in a clean, dry, safe location out of reach of children and other unauthorized people.
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Prior to performing any inspection, maintenance, or cleaning of the Pressure Blasting System, turn off the air compressor. Turn the Media
SKU 93889 For technical questions, please call | PAGE 12 |
